D-Link DIS-100G-10 - industrial unmanaged Layer 2 Ethernet switch, black

The D-Link DIS-100G-10 is a 10-port Gigabit industrial unmanaged switch with 2 SFP ports. This plug-and-play Layer 2 device expands wired network capacity without the need for manual configuration. It provides eight Gigabit Ethernet RJ45 ports and two dedicated SFP slots for fibre uplinks, supporting data transfer rates of up to 1 Gbit/s. The switch uses standard protocols to forward traffic, learning hardware addresses to direct frames to their intended destinations. This design eliminates the need for management interfaces or external controllers in the field. Installation is straightforward: simply connect the cables to integrate the hardware into the network.

Designed for demanding environments, the switch features an IP40-rated enclosure that protects against dust and small objects. It mounts directly onto standard DIN rails for secure placement within factory or outdoor control cabinets. Measuring 44 x 108 x 138 mm, the 620 g chassis fits into constrained spaces. The fanless, passive cooling design reduces noise and minimises mechanical wear. Front-facing LEDs provide visual network status monitoring. The switch operates on 12 to 55 V DC, making it compatible with standard industrial power layouts.

• 20 Gbit/s switching capacity and a 14.88 Mpps forwarding rate maintain consistent data throughput under heavy local loads.
• 8,000-entry MAC address table accommodates extensive deployments with numerous connected sensors and control devices.
• Extended operating temperature range of -40 °C to 75 °C withstands severe climate variations in non-climate-controlled environments.
• Maximum power consumption of 6.99 W keeps energy usage low during continuous network operation.
• 9 KB jumbo frame support optimises large data transfers by reducing standard packet processing overhead.